Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 105

For example, you can make assignments to the bundle in the Relationships tab, add actions in
the Actions tab, and so on.
11 Review the configuration, then click one of the following:
Back: Allows you to make changes after reviewing the summary.
Finish: Creates the Imaging bundle as configured according to the settings listed on this
Summary page.
This bundle is not assigned to any device or group after it is created until you make that assignment
on a Relationships tab.
IMPORTANT: If this Imaging bundle has been created on a management device inside the firewall
and you are assigning it to a device outside the firewall, port 8089 must be open both ways
(PUBLIC -> PRIVATE, and PUBLIC <- PRIVATE).
If PXE is enabled on the device, the bundle's work is performed on the device before its operating
system starts when a device assigned to the ZENworks Image bundle boots.
Creating and Configuring the Third-Party Image Bundle for Automatic Imaging
You can use ZENworks to specify the third-party images that must be restored on a device. The
image that is taken with a third-party Imaging tool and restored by using a third-party Imaging
bundle will not have any partition information. Consequently, it creates only one single partition on
the destination hard disk. To prevent this issue, you must take an image by using ZENworks Control
Center or the Novell ZENworks Third Party Imaging utility in the maintenance
To configure the Third-Party Imaging settings:
1 In ZENworks Control Center, click Bundles in the left pane to display the Bundles panel.
2 Click New > Bundle to start the Create New Bundle Wizard.
3 In the Create New Bundle Wizard, select Imaging Bundle, then click Next.
4 On the Select Imaging Bundle Type page, select Third-Party Image.
5 Click Next to display the Define Details page.
6 Fill in the fields:
Bundle Name: Although bundles can be identified in ZENworks Control Center by their type
of icon, as well as the folder where they are listed, you should develop a naming scheme that
differentiates the ZENworks Image bundles that are listed together in a folder.
For more information, see
ZENworks 10 Configuration Management System Administration
Folder: Browse for the location where you want the ZENworks Image bundle to be displayed
in ZENworks Control Center. The folder must exist. You cannot specify a non-existent folder,
because ZENworks does not create them from this wizard.
Icon: Browse for and select an icon if you plan to use one on your desktop for this bundle.
Description: Provide a description to help you later recognize the exact purpose of this
ZENworks Image bundle.
7 Click Next to display the Select a Third-Party Image File page.
8 Fill in the fields:
Image File: Select the type of the image to be used in the bundle.
"Naming Conventions in ZENworks Control
mode.
Center" in the
Reference.
Using Imaging 105