Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 67

The interface where Bootp was enabled is visible in the list.
11 Click Preferred server.
12 Change the Pass through mode value to Bootp and DHCP.
13 Set up the relay agents:
13a Click Add.
13b In the Relay agent IP address box, type the local LAN IP address.
13c In the Target server IP address box, type the DHCP server IP address.
13d Click OK.
13e Change the Pass through mode value to Bootp and DHCP.
13f Perform
Step 1
13g Apply the configuration.
Configuring Bay Networks Equipment
Perform the following steps on the switch:
1 Enable DHCP for the client VLAN using the following command lines:
# config vlan1 ip
# dhcp enable
2 Configure IP helpers to forward DHCP requests from the device subnet to the TFTP server,
using the following command lines:
# config ip dhcp-relay
# create 10.0.0.1 10.1.1.2 mode dhcp state enable
# create 10.0.0.1 196.10.229.2 mode dhcp state enable
The command has the form
create
where is the IP address of the gateway that serves the PXE device, and
agent
address of the server that the DHCP frame should be forwarded to.
3 Save the configuration.
Configuring Filters on Switches and Routers
Some network devices filter network traffic that passes through them. Preboot Services makes use of
several different types of traffic, and all of these must be able to successfully pass through the router
or switch for the Preboot Services session to be successful. The Preboot Services session uses the
following destination ports:
Destination Ports for Preboot Services
Table 2-5
Component
DHCP and Proxy DHCP servers
TFTP server
novell-zmgprebootpolicy
to Step 5 again and specify the Proxy DHCP server IP address at
create agent server mode dhcp state enable
Port
UDP Ports 67, 68, and 4011
UDP Port 69
UDP Port 13331
server
Setting Up Preboot Services and Imaging
Step 3.
,
is the IP
67