Dump Mode; F.8 Dump Mode; Using The Zenworks Imaging Engine Menu To View Partition Information; Using The Imaging Maintenance Mode Prompt To View Partition Information - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

IMPORTANT: If you remove an installed ZENworks partition, you must immediately restore
a base image with a valid non-grub MBR (Master Boot Record). If you do not, the device
cannot boot properly.
2 Enter to make this change effective.
grub.s

F.8 Dump Mode

The mode command provides information about the device's hard drives and partitions.
-dump
To use the Dump mode:
Section F.8.1, "Using the ZENworks Imaging Engine Menu to View Partition Information," on
page 237
Section F.8.2, "Using the Imaging Maintenance Mode Prompt to View Partition Information,"
on page 237
F.8.1 Using the ZENworks Imaging Engine Menu to View
Partition Information
1 To display the ZENworks Imaging Engine menu, enter:
img
2 Click System information, then click Drive information.
Information concerning the hard drives and partitions is displayed.
F.8.2 Using the Imaging Maintenance Mode Prompt to View
Partition Information
Using the imaging maintenance mode prompt, the following example explains the syntax and
available parameters that you can use with the Dump (
img -dump [-geo]
where the parameter is optional.
-geo
You can abbreviate
-dump -geo
For more information, see:
"Command Details" on page 238
"Examples" on page 238
-dump
as .
-dg
) mode command:
ZENworks Imaging Engine Commands 237