Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 52

Prompt for Configuration When Booting from Diskette: Specifies whether to prompt for
these configuration settings when you boot a device with the bootable diskette and CD or
DVD. If you leave this option deselected, the device boots using the configuration settings that
you make here and you are not able to override the settings during bootup. If you select this
option, you are given the chance to change each setting during bootup.
Reboot Manually: Specifies whether you must reboot a device manually after it was booted
with the bootable diskette in automatic mode. (If the device was booted with the bootable
diskette in manual mode, you must always reboot the device manually.)
If you boot a device with the bootable diskette and you let the bootup process proceed in
automatic mode, the imaging engine starts and checks the Preboot server to see if an automatic
imaging operation should be performed. If so, it performs the imaging operation on the device
and quits. If not, it quits without doing anything. What happens next depends on whether you
select this option.
If you leave this option deselected, you are prompted to remove the bootable diskette and press
any key to reboot the device automatically to its native operating system. If you select this
option, the device doesn't reboot automatically, but instead displays the imaging maintenance
mode prompt, allowing you to perform additional imaging-related tasks at the prompt. This is
helpful if you want to do things like check the current partition information or the image-safe
data before rebooting to the native operating system.
ZENworks Partition Size (MB): Specifies the number of megabytes to allocate to the
ZENworks partition if you choose to create one locally on a device when you boot the device
with the bootable diskette. The default size is 150 MB, which is the smallest you should make
the partition. The maximum size allowed is 2048 MB (2 GB).
4 (Optional) In the Workstation IP Settings section on the CD Media Boot tab, fill in the fields:
Use DHCP: Specifies to obtain an IP address dynamically through DHCP. Use this option only
if DHCP is configured on your network.
Use the Following Static Address Information: Specifies to use a static IP address. If you
select this option, fill in the IP address, subnet mask, and gateway to be used.
DNS Button: This option is active only if a static IP address for the device is specified.
52 ZENworks 10 Configuration Management Preboot Services and Imaging Reference