Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual page 95

To override the default configuration at the folder or device level:
1 In ZENworks Control Center, click the Devices in the left pane to display the Devices panel in
the Managed tab.
2 Select one of the following in the Name column:
The Details option next to the Servers or Workstations folder
The Servers folder, then a server contained in the folder
The Workstations folder, then a workstation contained in the folder
3 On the page that is displayed, click the Settings tab to display the Settings page options.
4 Click Preboot Services to display the Preboot Services configuration page:
If you have not previously configured this folder or device, the following is displayed:
Current: (System) (Override settings)
and the Preboot Menu Options
on whether you are at the folder or device level.
5 To configure the settings for the folder or device, click Override.
The following is displayed:
Current: /Devices/Servers
Revert to settings from: (System)
and the Preboot Menu Options
on whether you are at the folder or device level.
6 Select which option to use:
Always Show Imaging Menu
Never Show Imaging Menu
Show Imaging Menu if CTRL+ALT is Pressed
PXE must be enabled on the device for the menu to be displayed.
7 Click Apply or OK.
OK: Enables the change and exits the page.
section is disabled for editing. The above text varies depending
section is enabled for editing. The above text varies depending
Setting Up Preboot Services and Imaging 95