Using The Zenworks Imaging Engine Menu To Partition; Using The Imaging Maintenance Mode Prompt To Partition - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

Using the imaging maintenance mode prompt, the following example explains the syntax and
available parameters that you can use with the various partition mode commands:
img -pa partition_number
img -pc partition_number -type=type [-size=size] [-cluster=cluster_size]
img -pd partition_number
img -pd -all
The Partition mode can be used in two ways:
Section F.6.1, "Using the ZENworks Imaging Engine Menu to Partition," on page 234
Section F.6.2, "Using the Imaging Maintenance Mode Prompt to Partition," on page 234
F.6.1 Using the ZENworks Imaging Engine Menu to Partition
1 Enter
2 Click Modify partitions to open the Partition Wizard.
3 Select a partition.
4 Select an option:
Active: Select a partition that you want to activate (make bootable), then click Active.
Add: Opens the Create New Partition window. Click a partition type, partition size, and cluster
size, then click OK.
Delete: Select a partition, then click Delete.
5 When finished, click Done.
For more information, see the table in
to Partition," on page
F.6.2 Using the Imaging Maintenance Mode Prompt to Partition
For more information, see:
"Command Details" on page 235
"Examples" on page 235
234 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
to display the ZENworks Imaging Engine menu, then click Partitioning.
img
234.
Section F.6.2, "Using the Imaging Maintenance Mode Prompt