Assigning Devices To Bundle Groups - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

4 Click Add as necessary to include the desired bundles.
5 In the Shortcut Location section, make sure all check boxes are deselected.
Imaging bundles do not use shortcut locations.
6 Click Next to display the Summary page.
7 Review the configuration, then click one of the following:
Back: Allows you to make changes after reviewing the summary.
Finish: Click to make the assignments.
When devices assigned to this Imaging bundle boot, they are imaged from the image contained in
the bundle.

3.4.2 Assigning Devices to Bundle Groups

1 In ZENworks Control Center, click Devices in the left pane to display the Devices panel in the
Managed tab.
2 In the Name column, click Servers or Workstations, then select the check boxes next to the
devices to be assigned.
3 Click Action > Add to Group to open the Add to Group Wizard:
4 Click Next to add to an existing group to display the Targets page:
Using Imaging 135