Assigning Imaging Bundles; Using The Devices Tab To Assign Bundles - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

Back: Allows you to make changes after reviewing the summary.
Finish: Creates the Imaging Script bundle as configured per the settings listed on this
Summary page.
This bundle is not assigned to any device or group after it is created until you make that assignment
on a Relationships tab.
IMPORTANT: If this Imaging bundle has been created on a management device inside the firewall
and you are assigning it to a device outside the firewall, port 8089 must be open both ways
(PUBLIC -> PRIVATE, and PUBLIC <- PRIVATE).
When a device assigned to the Imaging Script bundle boots, the bundle's work is performed on the
device before its operating system starts. In the imaging maintenance mode, the script is
downloaded as the
the script in order to apply the bundle. You can execute the script by using the
ZenAdvancedScript

3.4 Assigning Imaging Bundles

IMPORTANT: If you are assigning a Imaging bundle that has been created on a management
device inside the firewall to a device outside the firewall, port 8089 must be open both ways
(PUBLIC -> PRIVATE, and PUBLIC <- PRIVATE).
You can assign a bundle from the Devices or Bundles tabs, assign devices to bundle groups, and
assign bundles to non-registered devices:
Section 3.4.1, "Using the Devices Tab to Assign Bundles," on page 134
Section 3.4.2, "Assigning Devices to Bundle Groups," on page 135
Section 3.4.3, "Using the Bundles Tab to Assign Bundles," on page 136
Section 3.4.4, "Assigning Bundles to Non-Registered Devices," on page 137

3.4.1 Using the Devices Tab to Assign Bundles

1 In ZENworks Control Center, click Devices in the left pane to display the Devices panel in the
Managed tab.
2 In the Name column, click Servers or Workstations, select the check boxes of one or more
servers or workstations, click Action, then select Assign Bundle.
This starts the Assign Bundle Wizard.
3 In the Select Objects dialog box, select the bundle to be assigned, then click OK to display the
Bundles to be Assigned page:
134 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
file in the
ZenAdvancedScript
command.
directory. Subsequently, you must execute
/bin
sh /bin/