Configuring The Server Referral List - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

Task
Remove strings
from the list
Allow Overwrites
Select the Allow Preboot Services to Overwrite Existing Files when Uploading check box if you
want existing

2.5.4 Configuring the Server Referral List

Referral lists are used to make sure managed devices belonging to other Management Zones can
access their home zone. For more information, see
1 In ZENworks Control Center, click Configuration in the left pane to display the Configuration
tab, then if it's not expanded, click Management Zone Settings.
2 Click Device Management to expand its listing, then select Preboot Services to display the
configuration sections.
3 Locate and expand the Server Referral List section:
Figure 2-5
4 To configure a server referral list, complete the tasks in the following sections, as applicable:
"Configuring Imaging Servers in the Server Referral List" on page 90
"Configuring ZENworks Mixed Environment Imaging Servers" on page 91
Configuring Imaging Servers in the Server Referral List
To configure the List of Server IP Addresses and DNS Names list box, perform the tasks in the
following table:
90 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
Steps
1. In the Custom Hardware Type
dialog box, select one or more
strings, then click Remove.
2. Click OK to exit the dialog box.
3. Click Apply (located at the bottom
of the Preboot Services
configuration page) to save your
custom type changes.
files to be overwritten by a newer version when the image is taken.
.zmg
Server Referral List panel
Additional Details
You can use the Ctrl or Shift keys to
select multiple strings to remove them
from the list.
Section 1.3.5, "Server Referral List," on page 25.