Editing Imaging Work - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - PREBOOT SERVICES AND IMAGING REFERENCE 10.3 16-04-2010 User Manual

4 In the Bundle to Apply field, browse for and select the desired Imaging bundle.
5 Fill in remaining the fields to configure the type of device that you want to image in the
multicast session.
For more information on the Rule Construction dialog box, see
Box" on page
6 Click Apply at the bottom of the Preboot Services section to save the non-registered device
settings.
When devices fulfilling the requirements that you defined in these steps boot, they are imaged
from the image contained in the selected Imaging bundle.
7 To enable the multicast session, continue with
Bundle" on page

3.5 Editing Imaging Work

The Edit Imaging Work page allows you to view all images that have been recently applied to the
selected device, and the image that is currently assigned (known as its "effective" image).
To edit a server's or workstation's Preboot Services work:
1 In ZENworks Control Center, click Devices in the left pane to display the Devices panel in the
Managed tab.
2 In the Name column, click Servers or Workstations to display the devices.
3 Click a device.
The Summary tab should display. If not, select it.
4 In the Imaging Work section, click Advanced to start the Edit Imaging Work Wizard:
138 ZENworks 10 Configuration Management Preboot Services and Imaging Reference
82.
127.
"Rule Construction Dialog
"Enabling or Disabling a Multicast Image Set