Table of Contents
Advertisement
ZENworks Imaging Engine
E
Commands
After booting a device from an imaging boot media, you can use the img command at the Linux
bash prompt or the ZENworks
Take an image of the device's hard disks
Put down an image on the device's hard disks
View or manipulate the device's hard disk partitions
View the device's hardware configuration or image-safe data
Display a menu from which you can also perform all of these tasks
The ZENworks Imaging Engine is installed to the
imaging boot device is a diskette, a CD, or DVD, the
file, which is expanded during the imaging boot process. If the imaging boot method is Preboot
Services, the ZENworks Imaging Engine is downloaded to the device when booting.
Because the ZENworks Imaging Engine is a Linux application, the command syntax is case
sensitive. The overall syntax is:
img [mode]
where mode is any of the modes described in the following sections:
Section E.1, "Help Mode (img help)," on page 631
Section E.2, "Automatic Mode (img auto)," on page 632
Section E.3, "Make Mode (img make)," on page 633
Section E.4, "Restore Mode (img restore)," on page 635
Section E.5, "Session (Multicast) Mode (img session)," on page 639
Section E.6, "Partition Mode (img part)," on page 641
Section E.7, "ZENworks Partition Mode (img zenPartition)," on page 642
Section E.8, "Dump Mode (img dump)," on page 643
Section E.9, "Information Mode (img info)," on page 643
Each mode can be abbreviated to the first letter of its name. For example,
abbreviated as
.
img d
To access the ZENworks Imaging Engine menu and perform all of these tasks, enter
parameters.
E.1 Help Mode (img help)
Use Help mode to get information about the img command if you don't have this documentation
available.
®
Imaging Engine menu to do any of the following:
/bin
/bin
directory on the imaging boot device. If the
directory is actually archived in the root
img dump
ZENworks Imaging Engine Commands
E
can be
with no
img
631
Advertisement
Table of Contents
