Message Bar - Simrad SX90 - REFERENCE MANUAL REV D Reference Manual

Simrad SX90
138

Message Bar

The parameter dialog opens when you click the
Message Bar
button in the
Message Bar
menu is in turn opened by clicking the
menu. (► System Test menu on page 95) (► Setup menu on
page 89)
The sonar automatically issues messages when a disturbance
occur. The messages are grouped into four categories, and this
parameter dialog is used to select at which level warnings and
alarms shall be presented. Note that messages are also indicated
in the parameter dialog. (► Status on page 164)
Status
The is located at the bottom of the display. It
Message Bar
contains four buttons, one for each category of messages. These
buttons give an overview of the number of unread messages
currently in the system, and each of the four buttons gives access
to a menu where each message can be read, acknowledged and
deleted. When no messages are present, the four buttons are grey.
When one or more unread messages exists, the
buttons are yellow, while the
Operational Alarm
and buttons are red.
Error
Options
: Click to switch off the
Off
even if messages are issued.
: Click to allow the
On Error
error messages are issued by the sonar.
: Click to allow the
On Sys.Alarms
when system alarms are issued by the sonar.
: Click to allow the
On Op.Alarms
when operational alarms are issued by the sonar.
: Click to allow the
On Warning
warnings are issued by the sonar.
: Click to switch the
Always On
: Click to close the parameter dialog.
Close
: Click to access the on-line help.
Help
menu. The
System Test
button on the
Test
. It will not be shown,
Message Bar
to appear only when
Message Bar
Message Bar
to appear only
Message Bar
to appear only when
Message Bar
permanently on.
Message Bar
System Test
Setup
and
Warning
System Alarm
to appear only
307670/D