ITech IT6600C Series User Manual page 83

V (From V
S
V (From V
a
R
i
t
7
t
8
t
9
t
10
t
11
(1). The value used should be agreed between the vehicle manufacturer and
the equipment supplier to suit the proposed application.
(2). t
period, while t
(3). t
cranking period, while t
not start.
Test–5
For the details, please refer to the
How to Use
Take Test–2B as an example to introduce the procedures as follows:
1. Click Vehicle on the Menu screen to enter the vehicle test screen.
1) Press the up/down key to move the cursor to the Standards function
2) Press the up/down key to move the cursor to the Mode function setting
3) Press the up/down key to move the cursor to the Voltage Range
4) Press the up/down key to move the cursor to the t
2. Press [Run] in the Vehicle function interface.
3. Press [On/Off] on the front panel, turn on the output.
4. According
[Shift]+[5](Trigger) to trigger the output of the waveform.
4.7.5 LV123
LV123 has been compiled for the electrical characteristics of new energy
vehicles for major European car manufacturers. For its high-voltage system
parts, the state standard within its operating voltage range is defined. The
relevant parameters are introduced as follows:
) -4V to -7V
B
)
-2.5 to -6V with |V
B
0Ω to 0.02Ω
15 to 40ms
≤50ms
0.5 to 20s
5ms
5 to 100ms
=5 ms is typical of the case when engine starts at the end of the cranking
11
=100 ms is typical of the case when the engine does not start.
11
=10 ms is typical of the case when engine starts at the end of the
11
=100 ms is typical of the case when the engine does
11
setting and press the [Enter] key to confirm. Rotate the knob to select
SAEJ1113-11 and press the [Enter] key to confirm.
and press the [Enter] key to confirm. Rotate the knob to select Test–
2B and press the [Enter] key to confirm.
function setting and press the [Enter] key to confirm. Press the numeric
keys to set the voltage as V=12V and press [Enter] to confirm.
press the [Enter] key to confirm. Rotate the knob to set the duration of
pulse and press the [Enter] key to confirm.
to the selected
Copyright ©ITECH Electronic Co., Ltd.
-5V to -16V
|≤|V | -5 to -12V with |V
a S
0Ω to 0.02Ω
50 to 100ms
(1)
≤50ms
0.5 to 20s
(1)
10ms
10 to 100 ms
(2)
Load Dump Dynamic
trigger method, for
Power Supply Function
|≤|V |
a S
(1)
(1)
(3)
Behavior.
function setting and
d
example, press
74