ITech IT6600C Series User Manual page 145

Set the Soft Keyboard
The user can open the soft keyboard in the menu. When the parameter is set to
ON, the soft keyboard is enabled. And when setting parameters on the screen,
the soft keyboard appears. Convenient users directly touch screen to select the
number.
5.2 Configuration Menu Reference
Press [Shift] + [V-set] (Config) key and enter to configuration menu interface.
At this interface, user can setup the power supply output parameters, detailed
parameters are shown as follows.
Config Configuration menu of the power supply.
Priority Mode
Slew Config
Output Couple
Mode
CC/CV priority mode setting.
Mode
Loop Speed
Only Load
Battery Simulation
Slew Setting.
Mode
V-Rise/ I-Rise
V-Fall/ I-Fall
Set the output mode.
Mode
Wave
Volt AC/ Curr AC
Copyright ©ITECH Electronic Co., Ltd.
Mode Settings.
CV: Constant voltage loop priority mode.
CC: Constant current loop priority mode.
Loop response speed setting.
High: high speed.
Medium: medium speed.
Low: low speed.
Load mode only.
(This item is only displayed when CC is
prioritized.)
Battery simulator mode.
(This item is only displayed when Only
Load is enabled.)
Select the slew unit.
Time: describe the slew of the device in
terms of time.
Standard: standard slew, unit is V/ms or
A/ms.
Displays the voltage or current rise slew
setting according to the selected priority
mode. If CC priority mode is selected, the
parameter setting of I-Rise will be
displayed here.
Displays the voltage or current fall slew
setting according to the selected priority
mode. If CC priority mode is selected, the
parameter setting of I-Fall will be
displayed here.
DC: DC mode.
Waveform selection. (This item is only
displayed when in DCAC output mode.)
Displays the AC voltage or AC current
setting according to the selected priority
mode. If CC priority mode is selected,
the parameter setting of Curr AC will be
displayed here. (This item is only
displayed when in DCAC output mode.)
System-Related Functions
136