ITech IT6600C Series User Manual page 55

3. CH1/CH2: channel selection, Channel 1 or Channel 2.
4. 7.csv: the list file name to execute.
5. List display area: this area mainly displays the edited List, you can view this
list by sliding up and down.
6. Output values view area: displays the output voltage value, output current
value and output power value of the current channel.
7. Setting values view area (Normal mode): When CV is prioritized, the voltage
setting value, current upper limit value, current lower limit value, power
upper limit value, and power lower limit value are displayed. When CC is
prioritized, the current setting value, voltage upper limit value, voltage lower
limit value, power upper limit value, and power lower limit value are
displayed.
8. List edit button. The functions are described as follows.




9. Displays the List function relevant parameters, which can be viewed by
sliding up and down.








Edit List files
The following takes CV priority mode as an example to introduce the operation
of editing three test steps.
1. Press [Shift]+[I-set](List) on the front panel to enter the List function main
interface.
2. Click the [Edit] key on the screen and enter to the List file edit interface.
Run/Stop: run/stop the list function.
Pause: suspend list running. Resume: continue to run the list.
Open: select the List file to execute.
Edit: edit present list file.
Priority Mode: list running priority mode.
Slew Mode: slew unit.
Repeat Num: X/Y, X indicates the current number of cycles and Y
indicates the total number of cycles.
Tout: trigger output setting.
End Mode: end state setting.
Current Step: A/B, A indicates the number of current running steps and
B indicates the total number of steps.
RunState
RunTime
Copyright ©ITECH Electronic Co., Ltd.
Power Supply Function
46