ITech IT6600C Series User Manual page 41

Power Switch Introduction
User can adjust the switching knob directly to turn on or turn off the device. The
status of switching knob is as follows.
When the switching knob is in the OFF position, it can be rotated 90 degrees
clockwise to power on the device; when the switching knob is in the ON position,
it can be rotated 90 degrees counterclockwise to power off the device.
Turning the POWER Switch On
Check that the power cord is connected properly.
Flip the POWER switch to the ( ON ) side to turn the instrument on. The front
panel display will light up after a few seconds. It may take about 30 seconds or
so for the power supply to initialize before it is ready for use.
If a self-test error occurs, an error message will be displayed in the front panel.
Press the [Esc] button to try to clear the current fault status. The user can also
restart the instrument to try to clear the fault status. Wait until the power is turned
off and then start again. If the problem still cannot be solved after restarting,
please contact the ITECH engineer.
Turning the POWER Switch Off
Flip the POWER switch to the ( OFF ) side to turn the instrument off. When it is
turned off, the instrument interface will prompt "Please wait for the device power
down.", and the instrument will store the setting information before shutdown in
the group 1 nonvolatile memory.
After you turn the POWER switch off, wait at least 10 seconds after the fan stops
before you turn the POWER switch back on. Turning the instrument on too soon
after you turn it off can cause damage to the inrush current limiter circuit, as well
as reduce the life of components such as the POWER switch and the internal
input fuses.
3.2 Touch Screen Introduction
This series of power display is a touch screen LCD interface, users can select
and set parameters by hand touch.The touch function can be set in the system
menu.
This parameter determines the state of the touch screen.
1. Press the General under the system menu.
2. Press the Up/Down key or turn the knob to select the Touch Function and
press [Enter].

On: enable touch function.

Off: disable touch function.
Copyright ©ITECH Electronic Co., Ltd.
Getting Started
32