Mirror Port Commands; Port Monitor - SMC Networks TigerStack II SMC8848M Management Manual

M
This section describes how to mirror traffic from a source port to a target
port.
Command

port monitor

show port monitor Shows the configuration for a mirror port
port monitor
This command configures a mirror session. Use the no form to clear a
mirror session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
• interface - ethernet unit/port (source port)
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26/50)
• rx - Mirror received packets.
• tx - Mirror transmitted packets.
• both - Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is
for both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
IRROR
Table 26-1 Mirror Port Commands
Function
Configures a mirror session
C
P
ORT
HAPTER
C
OMMANDS
26
Mode Page
IC 26-1
PE 26-2
26-1