Spanning-Tree Port-Priority; Spanning-Tree Edge-Port - SMC Networks TigerStack II SMC8848M Management Manual

S T
PANNING REE

spanning-tree port-priority

This command configures the priority for the specified interface. Use the
no form to restore the default.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
priority - The priority for a port. (Range: 0-240, in steps of 16)
Default Setting
128
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command defines the priority for the use of a port in the
Spanning Tree Algorithm. If the path cost for all ports on a switch are
the same, the port with the highest priority (that is, lowest value) will
be configured as an active link in the spanning tree.
• Where more than one port is assigned the highest priority, the port
with lowest numeric identifier will be enabled.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree port-priority 0
Related Commands
spanning-tree cost (29-16)

spanning-tree edge-port

This command specifies an interface as an edge port. Use the no form to
restore the default.
Syntax
[no] spanning-tree edge-port
29-18
C
OMMANDS