SMC Networks TigerStack II SMC8848M Management Manual page 595

Example
The following shows LACP enabled on ports 10-12. Because LACP has
also been enabled on the ports at the other end of the links, the show
interfaces status port-channel 1 command shows that Trunk1 has been
established.
Console(config)#interface ethernet 1/10
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/12
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
Flow control:
Port security:
Max MAC count:
Current status:
Created by:
Link status:
Operation speed-duplex: 1000full
Flow control type:
Member Ports:
Console#
1000T
00-30-F1-D4-73-A4
Up
Auto
10half, 10full, 100half, 100full, 1000full
Disabled
Disabled
0
Lacp
Up
None
Eth1/10, Eth1/11, Eth1/12,
LACP
25-5