Service Dhcp - SMC Networks TigerStack II SMC8848M Management Manual

Command
*
host
client-identifier
hardware-address
clear ip dhcp binding Deletes an automatic address binding from
show ip dhcp
binding
* These commands are used for manually binding an address to a client.

service dhcp

This command enables the DHCP server on this switch. Use the no form
to disable the DHCP server.
Syntax
[no] service dhcp
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
If the DHCP server is running, you must restart it to implement any
configuration changes.
Example
Console(config)#service dhcp
Console(config)#
Table 35-4 DHCP Server Commands (Continued)
Function
Specifies the IP address and network mask
to manually bind to a DHCP client
Specifies a client identifier for a DHCP
*
client
Specifies the hardware address of a DHCP
*
client
the DHCP server database
Displays address bindings on the DHCP
server
DHCP S
ERVER
Mode Page
DC 35-16
DC 35-17
DC 35-18
PE 35-19
PE, 35-20
NE
35-7