Ip Access-Group - SMC Networks TigerStack II SMC8848M Management Manual

A C
CCESS ONTROL
Example
Console#show ip access-list standard
IP standard access-list david:
permit host 10.1.1.21
permit 168.92.0.0 255.255.15.0
Console#
Related Commands
permit, deny 23-4

ip access-group (23-8)

ip access-group
This command binds a port to an IPv4 ACL. Use the no form to remove
the port.
Syntax
[no] ip access-group acl_name in
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• in – Indicates that this list applies to ingress packets.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• A port can only be bound to one ACL.
• If a port is already bound to an ACL and you bind it to a different
ACL, the switch will replace the old binding with the new one.
Example
Console(config)#int eth 1/2
Console(config-if)#ip access-group standard david in
Console(config-if)#
Related Commands
show ip access-list (23-7)
23-8
L C
IST OMMANDS