Mirror Port Commands; Port Monitor; Table 4-45 Mirror Port Commands - SMC Networks 6152L2 - annexe 1 Management Manual

C L
OMMAND INE

Mirror Port Commands

This section describes how to mirror traffic from a source port to a target
port.
Command

port monitor

show port monitor Shows the configuration for a mirror port
port monitor
This command configures a mirror session. Use the no form to clear a
mirror session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
• interface - ethernet unit/port (source port)
• rx - Mirror received packets.
• tx - Mirror transmitted packets.
• both - Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is
for both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
4-160
I
NTERFACE

Table 4-45 Mirror Port Commands

Function
Configures a mirror session
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-30)
Mode Page
IC 4-160
PE 4-161