SMC Networks TigerStack II SMC8848M Management Manual page 645

Gigabit ethernet switch
Hide thumbs Also See for TigerStack II SMC8848M:
Table of Contents

Advertisement

A VLAN is a group of ports that can be located anywhere in the network,
but communicate as though they belong to the same physical segment.
This section describes commands used to create VLAN groups, add port
members, specify how VLAN tagging is used, and enable automatic
VLAN registration for the selected interface.
Command Groups
GVRP and
Bridge Extension
Editing VLAN Groups Sets up VLAN groups, including name, VID and
Configuring VLAN
Interfaces
Displaying VLAN
Information
Configuring Private
VLANs
Configuring Protocol
VLANs
VLAN C
Table 30-1 VLAN Commands
Function
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for
bridge extension MIB
state
Configures VLAN interface parameters,
including ingress and egress tagging mode,
ingress filtering, PVID, and GVRP
Displays VLAN groups, status, port members,
and MAC addresses
Configures private VLANs, including uplink and
downlink ports
Configures protocol-based VLANs based on
frame type and protocol
C
HAPTER
OMMANDS
30
Page
30-2
30-7
30-9
30-16
30-17
30-19
30-1

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TigerStack II SMC8848M and is the answer not in the manual?

This manual is also suitable for:

8824m - annexe 1Tigerstack ii smc8824m

Table of Contents