Router Rip; Default-Metric - SMC Networks TigerStack II SMC8848M Management Manual

router rip

This command enables Routing Information Protocol (RIP) routing for all
IP interfaces on the router. Use the no form to disable it.
Syntax
[no] router rip
Command Mode
Global Configuration
Default Setting
Disabled
Command Usage
• RIP is used to specify how routers exchange routing table information.
• This command is also used to enter router configuration mode.
Example
Console(config)#router rip
Console(config-router)#
Related Commands
network (37-12)

default-metric

This command sets the default metric assigned to external routes imported
from other protocols. Use the no form to restore the default value.
Syntax
default-metric metric-value
no default-metric
metric-value – Metric assigned to external routes. (Range: 0-15)
Command Mode
Router Configuration
Default Setting
8
R I
OUTING NFORMATION
P (RIP)
ROTOCOL
37-9