Configuring Ip Routing Interfaces - SMC Networks TigerStack II SMC8848M Management Manual

Configuring IP Routing Interfaces

You can specify the IP subnets connected to this router by manually
assigning an IP address to each VLAN, or by using the RIP dynamic
routing protocol to identify routes that lead to other interfaces by
exchanging protocol messages with other routers on the network.
Command Usage
• If this router is directly connected to end node devices (or connected to
end nodes via shared media) that will be assigned to a specific subnet,
then you must create a router interface for each VLAN that will support
routing. The router interface consists of an IP address and subnet mask.
This interface address defines both the network number to which the
router interface is attached and the router's host number on that
network. In other words, a router interface address defines the network
and subnetwork numbers of the segment that is connected to that
interface, and allows you to send IP packets to or from the router.
• Before you configure any network interfaces on this router, you should
first create a VLAN for each unique user group, or for each network
application and its associated users. Then assign the ports associated with
each of these VLANs.
Command Attributes
• VLAN – ID of configured VLAN (1-4093).
• IP Address Mode – Specifies whether the IP address for this interface
is statically assigned, or obtained from a network address server.
(Options: Static, DHCP - Dynamic Host Configuration Protocol,
BOOTP - Boot Protocol; Default: Static)
- If Static address type is selected, then you must also specify whether
the IP address is the primary IP address on the VLAN or a secondary
IP address. An interface can have only one primary IP address, but
can have multiple secondary IP addresses. In other words, you will
need to specify secondary addresses if more than one IP subnet can
accessed via this interface.
C IP R
ONFIGURING
I
OUTING NTERFACES
17-7