Client-Identifier - SMC Networks TigerStack II SMC8848M Management Manual

is used (see page 4-253). This command is valid for manual bindings
only.
• The no host command only clears the address from the DHCP server
database. It does not cancel the IP address currently in use by the host.
Example
Console(config-dhcp)#host 10.1.0.21 255.255.255.0
Console(config-dhcp)#
Related Commands

client-identifier (35-17)

hardware-address (35-18)
client-identifier
This command specifies the client identifier of a DHCP client. Use the no
form to remove the client identifier.
Syntax
client-identifier {text text | hex hex}
no client-identifier
• text - A text string. (Range: 1-15 characters)
• hex - The hexadecimal value.
Default Setting
None
Command Mode
DHCP Pool Configuration
Command Usage
• This command identifies a DHCP client to bind to an address
specified in the host command. If both a client identifier and hardware
address are configured for a host address, the client identifier takes
precedence over the hardware address in the search procedure.
• BOOTP clients cannot transmit a client identifier. To bind an address
to a BOOTP client, you must associate a hardware address with the
host entry.
DHCP S
ERVER
35-17