Dot1X Timeout Tx-Period; Show Dot1X - SMC Networks TigerStack II SMC8848M Management Manual

U A
SER UTHENTICATION

dot1x timeout tx-period

This command sets the time that an interface on the switch waits during an
authentication session before re-transmitting an EAP packet. Use the no
form to reset to the default value.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout tx-period 300
Console(config-if)#

show dot1x

This command shows general port authentication related settings on the
switch or a specific interface.
Syntax
show dot1x [statistics] [interface interface]
• statistics - Displays dot1x status for each port.
• interface
• ethernet unit/port
Command Mode
Privileged Exec
22-44
C
OMMANDS
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26/50)