Static Multicast Routing Commands; Ip Igmp Snooping Vlan Mrouter; Table 33-4 Static Multicast Routing Commands - SMC Networks TigerStack II SMC8848M Management Manual

Static Multicast Routing Commands

Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter

ip igmp snooping vlan mrouter

This command statically configures a multicast router port. Use the no
form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4093)
• interface
• ethernet unit/port
• port-channel channel-id (Range: 1-32)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not
always be able to locate the IGMP querier. Therefore, if the IGMP
querier is a known multicast router/switch connected over the network
to an interface (port or trunk) on your router, you can manually
configure that interface to join all the current multicast groups.

Table 33-4 Static Multicast Routing Commands

Function
Adds a multicast router port
Shows multicast router ports
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26/50)
S M
TATIC ULTICAST
R C
OUTING OMMANDS
Mode Page
GC
PE
33-11
33-11
33-12