Table of Contents
Advertisement
C
L
OMMAND
INE
Mirror Port Commands
This section describes how to mirror traffic from a source port to a target
port.
Command
port monitor
show port
monitor
port monitor
This command configures a mirror session. Use the no form to clear a
mirror session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
• interface - ethernet unit/port (source port)
- unit - This is unit 1.
- port - Port number. (Range: 1-8)
• rx - Mirror received packets.
• tx - Mirror transmitted packets.
• both - Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is
for both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet Ports 1-8, destination port)
4-182
I
NTERFACE
Table 4-46 Mirror Port Commands
Function
Configures a mirror session
Shows the configuration for a mirror port
Mode Page
IC
4-182
PE
4-183
Advertisement
Table of Contents
