Ip Filter Commands; Management - SMC Networks TigerStack II SMC8848M Management Manual

U A
SER UTHENTICATION

IP Filter Commands

This section describes commands used to configure IP management
access to the switch.
Command

management

show management Displays the switch to be monitored or
management
This command specifies the client IP addresses that are allowed
management access to the switch through various protocols. Use the no
form to restore the default setting.
Syntax
[no] management {all-client | http-client | snmp-client |
telnet-client} start-address [end-address]
• all-client - Adds IP address(es) to the SNMP, web and Telnet
groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
• end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
22-48
C
OMMANDS
Table 22-14 IP Filter Commands
Function
Configures IP addresses that are allowed
management access
configured from a browser
Mode Page
GC 22-48
PE 22-49