Igmp Query Commands - SMC Networks TigerStack II SMC8848M Management Manual

M F
ULTICAST ILTERING
Example
The following shows the multicast entries learned through IGMP
snooping for VLAN 1:
Console#show mac-address-table multicast vlan 1 igmp-snooping
VLAN M'cast IP addr. Member ports Type
---- --------------- ------------ -------
1
Console#

IGMP Query Commands

This section describes commands used to configure Layer 2 IGMP query
on the switch.
Command
ip igmp snooping querier Allows this device to act as the
ip igmp snooping
query-count
ip igmp snooping
query-interval
ip igmp snooping
query-max-response-time
ip igmp snooping
router-port-expire-time
ip igmp snooping querier
This command enables the switch as an IGMP querier. Use the no form to
disable it.
Syntax
[no] ip igmp snooping querier
Default Setting
Enabled
33-6
C
OMMANDS
224.1.2.3 Eth1/11
Table 33-3 IGMP Query Commands
Function
querier for IGMP snooping
Configures the query count
Configures the query interval
Configures the report delay
Configures the query timeout
IGMP
Mode Page
GC 33-6
GC 33-7
GC 33-8
GC 33-9
GC 33-10