Access-List Ipv6 - SMC Networks TigerStack II SMC8848M Management Manual

A C
CCESS ONTROL

access-list ipv6

This command adds an IP access list and enters configuration mode for
standard or extended IPv6 ACLs. Use the no form to remove the specified
ACL.
Syntax
[no] access-list ipv6 {standard | extended} acl_name
• standard – Specifies an ACL that filters packets based on the source
IP address.
• extended – Specifies an ACL that filters packets based on the
destination IP address, and other more specific criteria.
• acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• When you create a new ACL or enter configuration mode for an
existing ACL, use the permit or deny command to add new rules to
the bottom of the list. To create an ACL, you must add at least one
rule to the list.
• To remove a rule, use the no permit or no deny command followed
by the exact text of a previously configured rule.
• An ACL can contain up to 32 rules.
Example
Console(config)#access-list ipv6 standard david
Console(config-std-ipv6-acl)#
Related Commands
permit, deny (23-11)
ipv6 access-group (23-15)
show ipv6 access-list (23-14)
23-10
L C
IST OMMANDS