Media-Type - SMC Networks TigerStack II SMC8848M Management Manual

I C
NTERFACE OMMANDS
To enable flow control under auto-negotiation, "flowcontrol" must
be included in the capabilities list for any port
• Avoid using flow control on a port connected to a hub unless it is
actually required to solve a problem. Otherwise back pressure
jamming signals may degrade overall performance for the segment
attached to the hub.
Example
The following example enables flow control on port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#flowcontrol
Console(config-if)#no negotiation
Console(config-if)#
Related Commands
negotiation (24-5)
capabilities (flowcontrol, symmetric) (24-6)

media-type

This command forces the port type selected for combination ports 21-24/
45-48. Use the no form to restore the default mode.
Syntax
media-type mode
no media-type
mode
• copper-forced - Always uses the built-in RJ-45 port.
• sfp-forced - Always uses the SFP port (even if module not
• sfp-preferred-auto - Uses SFP port if both combination types
Default Setting
sfp-preferred-auto
Command Mode
Interface Configuration (Ethernet)
24-8
installed).
are functioning and the SFP port has a valid link.