Event Logging Commands; Table 20-8 Event Logging Commands - SMC Networks TigerStack II SMC8848M Management Manual

S M
YSTEM ANAGEMENT

Event Logging Commands

This section describes commands used to configure event logging on the
switch.
Command
logging on
logging history
logging host
logging facility
logging trap
clear log
show logging
show log
logging on
This command controls logging of error messages, sending debug or error
messages to a logging process. The no form disables the logging process.
Syntax
[no] logging on
Default Setting
None
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to switch memory
or sent to remote syslog servers. You can use the logging history
20-34
C
OMMANDS

Table 20-8 Event Logging Commands

Function
Controls logging of error messages
Limits syslog messages saved to switch
memory based on severity
Adds a syslog server host IP address that will
receive logging messages
Sets the facility type for remote logging of
syslog messages
Limits syslog messages saved to a remote
server based on severity
Clears messages from the logging buffer
Displays the state of logging
Displays log messages
Mode Page
GC 20-34
GC 20-35
GC 20-36
GC 20-37
GC 20-38
PE 20-39
PE 20-40
PE 20-42