Ip Rip Send Version - SMC Networks TigerStack II SMC8848M Management Manual

Command Usage
• Use this command to override the global setting specified by the RIP
redistribute command.
• You can specify the receive version based on these options:
- Use "none" if you do not want to add any dynamic entries to the
routing table for an interface. (For example, you may only want to
allow static routes for a specific interface.)
- Use "1" or "2" if all routers in the local network are based on RIPv1
or RIPv2, respectively.
- Use "1 2" if some routers in the local network are using RIPv2, but
there are still some older routers using RIPv1.
Example
This example sets the interface version for VLAN 1 to receive RIPv1
packets.
Console(config)#interface vlan 1
Console(config-if)#ip rip receive version 1
Console(config-if)#
Related Commands
redistribute (37-15)

ip rip send version

This command specifies a RIP version to send on an interface. Use the no
form to restore the default value.
Syntax
ip rip send version {none | 1 | 2 | v2-broadcast}
no ip rip send version
• none - Does not transmit RIP updates.
• 1 - Sends only RIPv1 packets.
• 2 - Sends only RIPv2 packets.
• v2-broadcast - Route information is broadcast to other routers with
RIPv2.
Command Mode
Interface Configuration (VLAN)
R I
OUTING NFORMATION
P (RIP)
ROTOCOL
37-17