Class Maps Tab - Cisco VS-C6509E-S720-10G User Manual

C6576M QoS Dialog Box

Class Maps Tab

Figure 6-98
Figure 6-98 Class Maps Tab of C6576M QoS Dialog Box
Class Maps Area
The Class Maps area of the C6576M QoS dialog box describes globally defined class maps on the
device. Class maps identify a selected stream of IP traffic based on a defined set of matching criteria.
This tab contains the following information:
•
•
•
•
Cisco 6500/7600 Series Manager User Guide
6-124
shows the Class Maps tab of the C6576M QoS dialog box.
Class Maps Table—Lists globally defined class maps on the device.
Class Map Name—Unique identifier of a class map on the managed device.
–
Type—Indicates whether the class map can be used on Ethernet interfaces or not. The C65/76M
EMS will discover class maps that are not suitable for use with Ethernet interfaces, however you
cannot add, remove, or configure these class maps. They are listed in the table only to indicate that
the class map names are in use. This attribute has one of the following values:
– ethernet—The class map can be used on Ethernet interfaces.
other—Indicates that a class map contains more than one match entry or it contains a match
–
criteria that is unsupported on Ethernet interfaces.
– empty—Indicates a class map with no match entries. An empty class map cannot be applied to
an Ethernet interface, however you may modify it.
Match Condition—Specifies whether to match all criteria in the class map or any criteria in the list.
Match IP Precedence—Specifies IP Precedence values to match. Up to eight values may be
specified. If no values are specified, IP Precedence matching criteria is disabled. This attribute may
only have a value if the Type attribute is ethernet (1) and both Match DSCP and Match ACL
attributes are nil.
Chapter 6 Logical Object Dialog Boxes