Table of Contents
Advertisement
Getting Started
This chapter describes the typical tasks to be completed when first using the Cisco 6500/7600 Series
Manager, and consists of the following sections:
•
•
•
•
Preparing to Use the C65/76M Software
The following table outlines the general steps involved in using the C65/76M software.
Table 3-1
Step 1
Step 2
Step 3
Step 4
Step 5
Preparing to Use the C65/76M Software, page 3-1
Using Cisco EMF, page 3-2
Deploying C65/76M Objects, page 3-7
Launching Object Management Dialogs, page 3-10
Using C65/76M
Steps
Install and start Cisco EMF.
Install the C65/76M software.
Set up the Catalyst 6000 family
switch or the Cisco 7600 series
Internet Router.
Start a Cisco EMF session.
Deploy objects.
C H A P T E R
Description
Refer to the Cisco Element Management
Framework Installation and Administration
Guide for more information on how to
install and start Cisco EMF.
Refer to the Cisco 6500/7600 Manager
Installation Guide for more information.
You must configure the Catalyst 6000
family switch or Cisco 7600 series Internet
Router before it can be properly managed by
Cisco EMF. Refer to the "Hardware
Configuration Requirements" section in the
Cisco 6500/7600 Manager Installation
Guide for more information.
Starting a Cisco EMF user session provides
access to all C65/76M functionality.
Refer to the
"Deploying C65/76M Objects"
section of this chapter for more information.
Cisco 6500/7600 Series Manager User Guide
3
3-1
Hide quick links:
Advertisement
Table of Contents
