Chapter 5
Physical Object Dialog Boxes
Note
The Bandwidth attribute is an informational parameter used only to communicate the current bandwidth
to the higher-level protocols (such as IGRP, EIGRP, and OSPF); you cannot adjust the actual bandwidth
of an interface with this command.
Layer 2 Area
The Layer 2 area contains the following information:
•
Layer 3 Area
The Layer 3 area contains the following information:
•
•
•
ATM/SONET Tab
Figure 5-73
Figure 5-73 ATM/SONET Tab of the C6576M OSM POS Interface Dialog Box
MTU—The size of the largest datagram (frame) which can be sent or received on the interface,
specified in octets.
IP Address—Displays the IP address of the layer 3 interface.
Netmask—Subnet mask of the IP address. Enabled bits indicate network addressing bits in the IP
address.
Clear IP Address button—After receiving confirmation, will unset the IP address for this interface.
shows the ATM/SONET tab of the C6576M OSM POS Interface dialog box.
C6576M OSM POS Interface Dialog Box
Cisco 6500/7600 Series Manager User Guide
5-141