Cisco VS-C6509E-S720-10G User Manual page 59

Chapter 4 Deploying the C65/76M
Deployment and Commissioning Process
Figure 4-5 Network Element Dialog Box
When the dialog box is displayed, select the Configuration tab. In the CLI Passwords section, specify
the Telnet Password and Enable Password parameters. The Telnet Password is the password used to
connect to the switch using the Telnet protocol. The Enable Password is the password used to enter the
enable mode on the switch or router. All values entered in these text fields will be displayed as "*".
To specify the SNMP read and write community strings, select the SNMP tab and enter the correct
SNMP read/write community strings.
Note The IP Discovery process only fills in the SNMP community strings based on the version of SNMP
discovered on the switch or router. In Figure 4-6, the read and read-write community strings are
specified as public and private, respectively, because "private" was specified in the IP Discovery
window (see Figure 4-3). The community string used in the IP Discovery window should be the
read-write SNMP community.
Cisco 6500/7600 Series Manager User Guide
4-9