Cisco VS-C6509E-S720-10G User Manual page 422

C6576M QoS Policy Map Dialog Box
•
Note The Max. Burst attribute is not supported in 12.1(8a)E and earlier.
•
•
Note The Policy Violate Action is not supported in IOS 12.1(6)E and earlier. A PFC2 card is also required.
Conform Action Subarea
•
•
•
Microflow Policing Subarea
This is supported in Native IOS only.
Cisco 6500/7600 Series Manager User Guide
6-132
Max. Burst—Maximum burst size, in bytes, in bytes to enforce against policed traffic.A value of 0
is returned on read if an explicit policer is not defined for the policy map class.
Exceed Action—Action to be taken when policed traffic exceeds QoS parameters.
– Drop—Drops packet.
Policed DSCP Transmit—Changes the DSCP as per the policed DSCP map before transmitting.
–
Transmit—Transmits packet.
–
A value of none (0) is returned on read if an explicit policer is not defined for the policy map
–
class.
Violate Action—Action to be taken when policed traffic violates QoS parameters.
Drop—Drops packet.
–
Policed DSCP Transmit—Changes the DSCP as per the policed DSCP map before transmitting.
–
– Transmit—Transmits packet.
– A value of none (0) is returned on read if an explicit policer is not defined for the policy map
class or a violate action has not been explicitly configured for the policy map class.
Conform Action—Action to be taken when Policed traffic conforms to QoS parameters. This
attribute may have one of the following values:
– Drop—Drops packet
– Transmit—Transmita packet
Set DSCP—Assigns DSCP value to packet before it is transmitted.
–
Set Precedence—Assigns IP Precedence value to packet before it is transmitted.
–
A value of none (0) is returned on read if an explicit policer is not defined for the policy map
–
class.
Set DSCP—DSCP value assigned to packets of conforming ingress traffic before transmitting on
egress interfaces.This value is only relevant and will only be set in the running configuration of the
device if the Policy Conform Action is Set DSCP. A value of 0 is returned on read if an explicit
policer is not defined for the policy map class or the conform action is not Set DSCP.
Set IP Precedence—IP Precedence value assigned to packets of conforming ingress traffic before
transmitting on egress interfaces. This value is only relevant and will only be set in the running
configuration of the device if the Policy Conform Action is Set Precedence. A value of 0 is returned
on read if an explicit policer is not defined for the policy map class or the conform action is not Set
Precedence.
Chapter 6 Logical Object Dialog Boxes