C6576M QoS Dialog Box
•
Conform Action—Action to be taken when traffic conforms to QoS parameters. This attribute has
one of the following values:
Set DSCP—Integer DSCP value assigned to packets of conforming ingress traffic before
•
transmitting on egress interfaces. This value is only relevant and will only be set in the running
configuration of the device if the Conform Action attribute is Set DSCP.
Set IP Precedence—IP Precedence integer value assigned to packets of conforming ingress traffic
•
before transmitting on egress interfaces. This value is only relevant and will only be set in the
running configuration of the device if Conform Action is Set Precedence.
•
Exceed Action—Action to be taken when traffic exceeds QoS parameters. This atttribute has one of
the following values:
Violate Action—Action to be taken when traffic violates QoS parameters. This atttribute has one of
•
the following values:
The Violate Action feature is not supported in IOS 12.1(6)E and earlier. A PFC2 card is also required.
Note
•
New Policer button—Launches a subdialog box, shown in
policer on the managed device with the specified rate, burst, and max-burst values.
Cisco 6500/7600 Series Manager User Guide
6-122
–
Drop—Drops packet
–
Transmit—Transmits packet
–
Set DSCP—Assigns DSCP value to packet before it is transmitted.
–
Set Precedence—Assigns IP Precedence value to packet before it is transmitted.
A value of none (0) indicates no conform action has been specified.
–
–
Drop—Drops packet.
–
Policed DSCP Transmit—Changes the DSCP as per the policed DSCP map before transmitting.
Transmit—Transmits packet.
–
A value of none (0) indicates an exceed action has not been specified.
–
Drop—Drops packet.
–
Policed DSCP Transmit—Changes the DSCP as per the policed DSCP map before transmitting.
–
Transmit—Transmits packet.
–
–
A value of none (0) indicates that a violate action has not been specified.
Chapter 6
Logical Object Dialog Boxes
Figure
6-97, to create an aggregrate