Cisco VS-C6509E-S720-10G User Manual page 113

Chapter 4 Deploying the C65/76M
You can either click the Cancel button to cancel the operation or click the Finish button to create the
object. If the Chassis slot number corresponds to an occupied slot, an error message is displayed. The
message resembles the message shown in
Commissioning Predeployed Objects
A predeployed Network Element and subobjects are commissioned automatically when a coldStart
SNMP trap that is issued from the switch or the router is received by the CEMF server.
Note For the automatic commissioning to work, the switch or router must be configured to send SNMP traps
and the CEMF server host must be in the trap client list.
The subchassis discovery task is executed during commissioning. The discovery task does the following:
•
•
•
•
If the coldStart trap is not received by the CEMF server when the switch is first brought on-line, then
the predeployed Network Element object needs to be commissioned manually by opening the Network
Element dialog box and selecting the Commission button (see
Verifies the predeployed objects.
If a mismatch between the predeployed object and the discovered object exists, then the predeployed
object is placed in a Mismatched state. For example, if a Supervisor Engine 2 MSFC2 is predeployed
but a Supervisor Engine 1A MSFC2 is discovered, the Supervisor Module object will be placed in
a Mismatched state. If the wrong object was predeployed, delete the object and recommission the
Network Element. If the wrong module was inserted in the switch or router, insert the correct
module and recommission the object.
Checks for switch or router components that were not predeployed. Any objects that are discovered
will be created and commissioned automatically.
Automatically creates and commissions the remaining C65/76M objects. These objects include the
power supply and all of the logical objects.
Deployment and Commissioning Process
Figure 4-30.
Figure
Cisco 6500/7600 Series Manager User Guide
4-15).
4-63