Routing Protocol Tab - Cisco VS-C6509E-S720-10G User Manual

Chapter 5 Physical Object Dialog Boxes

Routing Protocol Tab

Figure 5-44
Figure 5-44 Routing Protocol Tab of the C6576M ATM T3 Interface Dialog Box
OSPF Area
The OSPF area contains the following information:
•
•
•
•
shows the Routing Protocol tab of the C6576M ATM T3 Interface dialog box.
OSPF Network Type—OSPF network type. ATM is a point-to-point service; by default it is
considered to be nonbroadcast by the OSPF routing process. An ATM interface can be configured
as a broadcast interface. The OSPF network type also can be dependent on the ATM network
configuration, whether or not the network is partially meshed or fully meshed.
Area ID—The predefined ID uniquely identifying the area to which the interface connects. It can be
specified as either a decimal value or as an IP address. Value is 0.0.0.0 if interface is a layer 2 (no
IP address assigned) interface. This attribute is read-only.
Authentication Key—Password to be used by neighboring OSPF routers on a network segment that
is using OSPF simple password authentication. It is ignored if OSPF Authentication Type is not
"simple". This attribute is read-only.
Hello Interval—Length of time between the hello packets sent on an OSPF interface. Must be
consistent between all routers on an attached network. This attribute is read-only.
C6576M ATM T3 Interface Dialog Box
Cisco 6500/7600 Series Manager User Guide
5-87