Cisco VS-C6509E-S720-10G User Manual page 219

Chapter 5 Physical Object Dialog Boxes
General Area
The General area contains the following information:
•
•
Note The Bandwidth attribute is an informational parameter used only to communicate the current bandwidth
to the higher-level protocols (such as IGRP, EIGRP, and OSPF); you cannot adjust the actual bandwidth
of an interface with this command.
•
Note The Delay attribute is an informational parameter used only to communicate the current bandwidth to
the higher-level protocols (such as IGRP and EIGRP); you cannot adjust the actual delay of an interface
with this command.
•
•
Layer 2 Area
The Layer 2 area contains the following information:
•
•
Layer 3 Area
The Layer 3 area contains the following information:
•
•
•
Link Up/Down Trap—Enables or disables linkUp and linkDown trap generation for the interface.
Bandwidth—Overwrites default bandwidth in kilobits per second.
Delay—Specifies the delay in tens of microseconds for an interface or network segment.
Input Queue Length—Input queue length in packets.
Output Queue Length—Output queue length in packets.
MAC Address—Displays the MAC address of the interface.
MTU—The size of the largest packet which can be sent or received on the interface, specified in
octets.
IP Address—Displays the IP address of the Layer 3 interface.
Netmask—Subnet mask of the interface IP address. Enabled bits indicate the network addressing
bits in the IP address.
Clear IP Address button - After receiving confirmation, will unset the IP address for this interface.
C6576M ATM SONET Interface Dialog Box
Cisco 6500/7600 Series Manager User Guide
5-105