Cisco VS-C6509E-S720-10G User Manual page 351

Chapter 6 Logical Object Dialog Boxes
–
–
• Cost—Describes the STP VLAN path cost of this interface. The VLAN path cost is only used on
trunking interfaces. On any switch port that is not in trunking mode, the STP port path cost is used
instead.
Note Default values for priority and cost will be used if you do not provide one of these arguments. You must
provide a nondefault value for at least one of these arguments, otherwise the action will fail.
• Add/Remove Per VLAN STP Setting button—Launches a subdialog box to add and remove an
explicit STP VLAN configuration to the interface. The configuration will only have an effect if the
interface is in trunking mode and the VLAN has an associated STP instance. The interface does not
currently need to be configured as a trunking port, nor does the VLAN or the VLAN STP instance
need to exist.
VLAN STP Setting button is selected. The subdialog box contains the following items:
–
–
–
–
–
CatOS 6.3:Integer(0..63)
CatOS 7.1:Integer(1..63)
Figure 6-49 shows the subdialog box that is displayed when the Add/Remove Per
VLAN—Idenifies the VLAN STP instance. This is the numeric identifier of the access mode
VLAN or a VLAN that is carried on the trunk.
Priority—Describes the STP VLAN port priority of this interface.
Cost—Describes the STP VLAN path cost of this interface.
Add button—Adds an explicit STP VLAN configuration to the interface.
Remove button—Removes an explicit STP VLAN configuration to the interface.
C6576M EtherChannel Dialog Box
Cisco 6500/7600 Series Manager User Guide
6-61