Object State Alarms - Cisco VS-C6509E-S720-10G User Manual

Chapter 8 Alarms and Alarm Management

Object State Alarms

Most C65/76M objects have state alarms associated with them. These state alarms can be used to
determine what tasks are being executed for the corresponding object or the status of network
connectivity to the corresponding object from the CEMF server. There will only be one state alarm for
each object at any time (corresponding to the current state of the object).
The following C65/76M objects have state alarms associated with them:
•
•
•
•
•
•
•
•
Network Element
Table 8-3
Table 8-3
State
discovery
discoverylostcomms
mismatched
normal
lostcomms
Network Element
Chassis
Power Supplies
All Modules
Port Adapters
Interfaces
Software Object
Logical Objects
describes the Network Element object state alarms.
Network Element State Alarms
Message/Description
"C6576M Network Element is in the
discovery state."
"C6576M Network Element is in the
discoverylostcomms state. Network
connectivity to switch has been lost
during discovery."
"C6576M Network Element is in the
mismatched state. IP address does not
correspond to a Catalyst 6500 switch."
"C6576M Network Element is in the
normal state."
"C6576M Network Element is in the
lostcomms state. Network connectivity
to the switch has been lost."
Severity Alarms Cleared
Informational discoverylostcomms
normal
mismatched
Critical discovery
Major discovery
Normal discovery
lostcomms
Critical normal
Cisco 6500/7600 Series Manager User Guide
C65/76M Alarms
8-9