Rep 3.6 Side Frame Assembly - Xerox Document Workcenter 150 Service Manual

REP 3.6
Side Frame Assembly
Part List on PL 7.1
CAUTION
Leaving the Ink Carbidge removed for tong
periods of time will cause the ink nozzles to
dry out. Image quality problems or a blank
print could iaesult. If necessary, prime the Ink
Cartddge after reinstallation.
1. Disconnect the Power Cord from the outlet.
2. Remove the following:
a. Ink Cartridge Cover (PL 3.1).
b. Ink Cartridge.
c.
Rear Cover (REP 1.2).
d.
Printer and Tray Assembly (REP 3.1).
a. Printer Assembly (REP 3.2).
3. Remove the Side Frame Assembly
(Figure 1).
a. Disconnect the Pump tube.
b. Remove the three (3) Side Frame
Assembly mounting screws.
c.
Carefully pull the Side Frame Assembly
out to access the Reverse Spring.
d. Dismnnect the Reverse Spring.
e. Remove the Side Frame Assembly.
Figure 1 Removing the Side Frame Assembly
REP 3.6 Side Frame Assembly
S/S%
4-14 Document WorkCenter 150