Switched 56 Kbps Network Connection; Isdn Dbm Network Connection - Paradyne COMSPHERE 3610 Replacement Manual

COMSPHERE 3600 Data Service Units
Switched 56 kbps
Network Connection
WARNING
Do not insert the 2-wire
switched 56 kbps plug into an
RJ11C jack providing PSTN
service. This type of jack is
intended for analog public
switched telephone network
(PSTN) devices. Doing so may
cause equipment damage and
harm to the telephone
network.
To make a physical connection to the switched 56 kbps
network:
Procedure
1. Plug one end of the switched 56 kbps network
interface cable into the DSU jack labeled
BACKUP. Verify that you have the right cable:
For a DSU with a . . .
2-wire Switched 56 DBM
4-wire Switched 56 DBM
2. Plug the other end of the cable into the modular
jack provided for the switched 56 kbps network
connection.
Switched 56 kbps
Network Connection
2-4
Use the . . .
6-pin cable
8-pin cable
Backup
5
V . 3
/ D C
C C
U P
C K
B A
E
L I N
E R
W
P O
SJA56
or SJA48
Wall Jack
495-14860
December 1996
ISDN DBM Network
Connection
The 2-wire ISDN DBM has an integral Network
Termination 1 (NT1). The NT1 provides the termination
of the ISDN U-interface from the network.
To make a physical connection to the ISDN network
U-interface:
Procedure
1. Plug one end of the ISDN network interface cable
into the DSU jack labeled BACKUP.
2. Plug the other end of the cable into the modular
jack provided for the ISDN network connection.
ISDN
Network Connection
3. Enter and save the following required fields:
SPID number(s) (SPID)
Switch type (SwitchTyp)
Local seven-digit telephone number(s) (Phone)
Refer to the Configuration Branch section in Chapter 3
and Appendix C, Ordering ISDN Service, in the DBM
Options Supplement for details.
Backup
5
V . 3
/ D C
C C
U P
C K
B A
E
L I N
E R
W
P O
SJA11
U-Interface
Connector
495-14580-01
3610-A2-GB43-50