Setting The Segment End Parameters - Dürkopp Adler D888 e-con Operating Instructions Manual

Programming Commander DELTA
Icon Parameter
Height of sewing foot lift
Sewing stop
Light barrier
(optional additional equipment)
The light barrier detects the beginning
and the end of the material. After a signal
was detected, sewing can continue
automatically with the specifically set
parameters.
Thread tension sensor mode
(Access only after activation in the
machine configuration)
Icon Parameter
Parameters Seam End
Sewing foot lift after trim
Height of sewing foot lift after trim
Thread trimmer
Bartack at seam end
Operating Instructions D888 e-con - 00.0 - 12/2023
5.7.6

Setting the Segment End parameters

There are various options for setting the Seam End parameters.
The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Settings
Value range
01 – 20 [mm]
(depending on subclass)
Value range
On/Off
( p. 152)
Value range
On/Off
( p. 153)
Settings
Value range
On/Off
Value range
01 – 20 [mm]
(depending on subclass)
Value range
On/Off
Value range
On/Off
115