Dürkopp Adler D888 e-con Operating Instructions Manual page 218

Code Type
2573 Error
2574 Error
2575 Error
2576 Error
2577 Error
2578 Error
2579 Error
2580 Error
2581 Error
2583 Error
2584 Error
2585 Error
2587 Error
216
Possible cause
Stepper card X70 sewing
motor encoder not connected
(Upper puller)
Stepper card X70 sewing
motor encoder not initialized
(Upper puller)
Stepper card X70 init position
not found (Upper puller)
Stepper card X70 not
enabled (Upper puller)
Stepper card X70 overload
(Upper puller)
Stepper card X70 encoder
failure (Upper puller)
Stepper card X70 Current
sensor failure (Upper puller)
Stepper card X70 Incorrect
stepping motor direction of
rotation (Upper Puller)
Stepper card X70 reference
drive failure (Upper puller)
Stepper card X70 overcurrent
(Upper puller)
Stepper card X70 parameter
initialization (Upper puller)
Stepper card X70 insulation
error (Upper puller)
Stepper card X70 transport
interval failure (Upper puller)
Corrective
• Replace the control
• Perform software update
• Check selection of class
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace the control
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace encoder
• Replace the control
• Replace encoder
• Check if plugs have been mixed up
• Check the wiring in the machine distribu-
tor and change it if necessary
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace the control
• Perform software update
• Check selection of class
• Check motor phase and PE for low-
impedance connection
• Replace encoder
• Replace sewing motor
• Perform software update
• Check selection of class
Operating Instructions D888 e-con - 00.0 - 12/2023
Troubleshooting